Description

The ADD-Vantage 9000 includes OEI’s patented magnetic filter element as well as a stainless steel cloth element. Systems are optimized for fluid viscosity, flow volume, flow rate, temperature, mobility, and mounting requirements. Depending on the application, both “inside-out” and “outside-in” flow control designs are offered.

Flow Control

“Inside-out” flow control designs are recommended because the magnetic filter element is the primary filter. Its high holding capacity allows for extended operating life of the stainless steel cloth element which minimizes bypassing and extends cleaning intervals.
“Outside-in” flow control operates with the stainless steel cloth element as the initial filter. The magnetic filter element acts as a secondary filter that enhances the systems filtration capability. If this filter goes into bypass, the magnetic filter element ensures continuous protection.

Benefits

» High holding capacity allows for extended planned maintenance periods
» Flows 43% more fluid or lube oil than conventional filters
» Continuous filtration in bypass
» Installs the same as conventional filters, no retrofitting required

Efficiency

Operating Parameters

Materials

Installation

Limited Warranty

Service Life

Cleaning

Magnetic Filter Element: Remove the contamination with a lab cloth/non-fiber cloth that absorbs the contamination. Save the cloth in a sample bag to send for analysis.

Stainless Steel Cloth Element: Separate the filter element from the bypass assembly and clean with a solvent, soap and water, a parts washer, or ultrasonically. Then let the element air dry.
Use the magnetic filter element as a predictive maintenance tool by removing contamination with a lab cloth or rubber glove and depositing it into a sample jar. Send the contamination for analysis to determine the source of equipment component wear and prevent system failure.